Outdoor Power Equipment, Small Engine, Lawn Mower Repairs, Troubleshooting and Safety
SEARCH THIS SITE:
Removal of Tank Mounted Pulsa Prime Carb from Briggs 10L900 Series Vertical Shaft Engine
-
- #1. 1/2 in. screw on side
Remove 1/2 in. screw above center of tank (#6).
-
- #2. Remove side shield if necessary
The side shield (flywheel guard - carburetor side) may be taken off to facilitate carb removal but it is not absolutely necessary (#7).
-
- #3. Rotate carb to disconnect throttle link
The carb and tank assembly can be removed by rotating the assembly and sliding out the throttle link rod (#8). In this photo the carb and tank have been maneuvered counter-clockwise 90 degrees.
-
-
- #4. Remove 5 screws
Separate the carb from the tank by removing five screws (#9).